This new item can reinforce the mold
cooling system, solving problems as
cracking or water leakage and
yet thinning the cavity wall
1. Prevent corrosion on the cooling
hole edge by considering the half
cap on a new mold manufacturing
2. Prevent water leakage from the
heat crack connected with
the cooling hole
・Thinning the cavity wall improve the cooling efficiency
・Easy to install
・No need to change any cooling tube or fitting
・The cooling hole process can be made with standard tools
・The cost is 10 times lower comparing with an usual cooling bush
・Can be removed and exchanged with a special jig
CHC is available in all our sites,
in Thailand, Indonesia, China and Mexico.
For detailed information please download the file: